Configuration of the Simatic Step7 - 300 Training Unit

Configuration of Version A
The programmable controller is configured with the following modules:
Slot 1: Power Supply 24V/5A
Slot 2: CPU 314 or CPU 315-2 DP
Slot 4: Digital input 16x24V Inputs from the simulator
Slot 5: Digital input 16x24V Thumbwheel buttons
Slot 6: Digital output 16x24V 0.5A Outputs from the simulator
Slot 7: Digital output 16x24V 0.5A Digital display
Slot 8: Digital input 16x24V Conveyor model inputs
Slot 9: Digital output 16x24V 0.5A Conveyor model outputs
Slot 10: Analog module 4 AI/4 AO Adjustable from the simulator

Configuration of Version B
The programmable controller is configured with the following modules:
Slot 1: Power Supply 24V/5A
Slot 2: CPU 314 or CPU 315-2 DP
Slot 4: Digital input 32x24V Inputs from the simulatorand thumbwheel buttons
Slot 5: Digital output 32x24V/0.5A Outputs from the simulatorand digital display
Slot 6: Digital input and output Conveyor model module 8X24V/ 8x24V 0.5A
Slot 7: Analog input 2 AI Analog section from simulator

Addresses
Fixed slot addressing is used for the  Simatic Step7 - 300™ (CPU 312-314). The module
addresses are shown in the slide.
The starting addresses of the modules can be set by parameter assignment on
the CPU 315-2DP and for Simatic Step7 - 400™.

Setup of a Training Area with Simatic Step7 - 400

Contents of the Training Kit

The training kit consists of the following components:

• An Simatic Step7-400™ programmable logic controller with CPU 412 or CPU 413-2DP

• Digital input and output modules, analog modules

• Simulator with digital and analog sections

• Conveyor model

Note:

It is quite possible that your training area is not equipped with the conveyor

model shown in the slide above, but rather with the conveyor model

pictured below.